Painless Wiring Replacement Wiring Harness (Stock Replacement) for Jeep CJ 1976-86.

Includes: Water Temp Sensor, Oil Gauge Sender, Alternator, Starter Solenoid, Tach Lead, Ballast Resistor and Fuel Tank Sender are NOT pre-terminated. Engine Harness: Back-up Light Switch (not engine/trans. specific), Chassis ground, Brake Failure Warning Switch, Horn, Windshield Washer, Heater Motor, Park and Signal Lights, Front Marker Light (w/bulb socket), Headlights, Fuses, Flashers, Horn Relay, Tachometer Lead, Ballast Resistor, Maxi Fuse, Terminal Ends, Wire ties and Grommets. NOTE: Harness #10110 is NOT equipped for computer controls nor is it engine specific. Water temp sender, oil gauge sender, alternator, starter solenoid, tach lead, ballast resistor and fuel tank sender are NOT pre-terminated.

Almost every circuit on this harness is pre-terminated at both ends. All wires are color coded and labeled and all wire leads are pre-cut to proper lengths. Our harness uses an OEM style bulkhead connector that attaches to the bulkhead without any special brackets or modifications. The blade type fuse block wiring is factory installed and machine crimped.